Exhaust Pipe Connector Sleeve Joiner 66mm to 69.5mm / 125mm

A heavy-duty exhaust pipe connector sleeve for joining two exhaust sections of the same diameter without welding. The adjustable coupler slides over the ends of pipes between 66mm and 69.5mm across and clamps them together to make a secure, strong join, whether you are fitting a new section or repairing a damaged or holed pipe.

• Fits pipe diameters: approximately 66mm to 69.5mm
• Length: approximately 125mm
• Heavy-duty construction for strength and durability
• Designed to join same-diameter pipes and tubes, no welding needed

Measure the outside diameter of both pipes before ordering, as the sleeve is made for equal-diameter sections and will not step between two different sizes.

Practical tip: clean the rust and scale off both pipe ends with a wire brush, push each pipe at least halfway into the sleeve, and tighten the clamps evenly. A leaking exhaust joint is picked up at the MOT, so check it before your test; see our pre-MOT checklist.